Front Camber

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Adjust the camber angle to the following value.

Tire size		Camber (difference between RH and LH 45' or less)
Sedan model	P225/55R17 P225/50R18	-0°15'±0°30'
OUTBACK model	P225/65R17 P225/60R18	0°00'±0°30'

Loosen the two flange nuts while holding the strut bolts.

Turn the camber adjusting bolt so that the camber is set at specification.

NOTE: Moving the adjusting bolt by one scale changes the camber by approximately 0°10'.

Fig 1: Identifying Camber Adjusting Bolt Turning Angle

Courtesy of SUBARU OF AMERICA, INC.

To increase camber.
Rotate the left side counterclockwise.	Rotate the right side clockwise.
Courtesy of SUBARU OF AMERICA, INC.	Courtesy of SUBARU OF AMERICA, INC.

To decrease camber.
Rotate the left side clockwise.	Rotate the right side counterclockwise.
Courtesy of SUBARU OF AMERICA, INC.	Courtesy of SUBARU OF AMERICA, INC.

Tighten two new flange nuts.
Tightening torque:

155 N.m (15.8 kgf-m, 114.3 ft-lb)

NOTE: While holding the adjusting bolt side, tighten the nut side.