LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> Outback 2.5i >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls (Diagnostics) (H4DO) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0617 Starter Relay Circuit High >> Model Without Push Button Start >> Wiring Diagram

Model Without Push Button Start: Wiring Diagram

Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON START) <Ref. to ENGINE PERFORMANCE (Legacy), ENGINE PERFORMANCE (Outback), Engine Electrical System.>

Fig 1: Starter Relay (High) - Wiring Diagram (Model Without Push Button Start)
G10263257Courtesy of SUBARU OF AMERICA, INC.
DIAGNOSTICS PROCEDURE

Step Check Yes No
1 CHECK FOR ANY OTHER DTC ON DISPLAY.  Is any other DTC displayed? Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". <Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .> Go to step 2  .
2 CHECK HARNESS BETWEEN ECM AND STARTER RELAY CONNECTOR  .
  1. Turn the ignition switch to OFF.
  2. Disconnect the connector from ECM.
  3. Turn the ignition switch to ON.
  4. Measure the voltage between ECM connector and chassis ground.

    Connector & terminal 

    (B134) No. 46 (+) - Chassis ground (-): 

    NOTE: For CVT model, place the select lever in "P" range or "N" range.
 Is the voltage 10 V or more? Repair the short circuit to power in harness between ECM connector and starter relay connector. Repair the poor contact of ECM connector.
scientia non olet · About LEMON Manuals