LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> Outback 2.5i >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Security And Locks - Keyless Access (W/Push Button Start) (Diagnostics) >> System Operation Check Mode >> Operation

System Operation Check Mode: Operation

  1. On «Main Menu» display, select «Each System Check».
  2. On «System Selection Menu» display, select «Keyless access system».
  3. On «Keyless access system» display, select «Work Support».
  4. Select «System Operation Check Mode».
  5. Select the check point and click [OK].
  6. Select [Exit] to exit the drive item mode.
    Data Keyless access CM output check Remarks
    Driver seat sensor power supply Output Perform the output check for the driver's door touch sensor.
    Stop
    Passenger seat sensor power supply Output Perform the output check for the passenger's door touch sensor.
    Stop
    STSW Output Turn on the STSW. (2)
    Stop
    ACC Output Turn on the ACC.
    Stop
    IGN1/2 Output Turn on the IGN1/2.
    Stop
    Start SW character illumination lighted Output Perform ON output of the push button ignition switch back-up light. (1)
    Stop
    Start SW indicator lighted (green) Output Perform ON output of the push button ignition switch back-up light. (1)
    Stop
    Start SW indicator lighted (orange) Output Perform ON output of the push button ignition switch back-up light. (1)
    Stop
    Steering lock power supply Output Output the power supply signal from keyless access CM to steering lock CM.
    Stop
    (1) When lit by a condition other than for a system operation check mode, it will not become unlit even when set to OFF or no output.
    (2) When performed with ignition switch ON, engine will start. Therefore, great care must be exercised.
    NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
scientia non olet · About LEMON Manuals