Front Axle Hub: Installation
NOTE:
- The following procedure is for LH side.
- Perform the same procedures for the RH and LH side.
- Installation of front axle hub & bearing assembly LH
- Install the front axle hub & bearing assembly to the steering knuckle with 4 bolts.
Standard value: T=65N.m {663kgf.cm} {47.9ft.lbf}
- Install the front axle hub & bearing assembly to the steering knuckle with 4 bolts.
- Inspection of front axle hub & bearing assembly axial play (Refer to ON-VEHICLE INSPECTION )
- Inspection of front axle hub & bearing assembly runout (Refer to ON-VEHICLE INSPECTION )
- Installation of speed sensor FR LH
- Install the speed sensor FR LH to the steering knuckle with a bolt.
Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
CAUTION:- Do not damage the tip of the speed sensor when installing the speed sensor body.
- Do not allow foreign matter to attach to the mounting surfaces.
- Be careful not to twist the speed sensor wire during installation.
- Install the speed sensor FR LH to the steering knuckle with a bolt.
- Installation of front disc (Refer to INSTALLATION )
- Installation of front disc brake caliper assembly LH (Refer to REPLACEMENT )
- Installation of front tire
Standard value: T=120N.m {1224kgf.cm} {88.5ft.lbf}
- Inspection of test mode (speed sensor check) (Refer to WORK SUPPORT )