Inspection steps
WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Before performing the diagnosis, refer to the
PRECAUTIONS
.
- Check DTC
- Read the DTC for the occupant detection system.
Criteria: No other DTC is detected.
NG: Perform the diagnosis according to the DTC.
OK: Go to Next Step
- Read the DTC for the occupant detection system.
- Check poor contact of connectors.
- Check for poor contact of the connectors between the occupant detection control module and the airbag control module.
Criteria: No fault is found.
NG: Connect the connectors properly. In the case that the fault cannot be corrected, replace the airbag rear harness along with the body harness, or replace the front seat cushion ASSY RH.
OK: Go to Next Step
- Check for poor contact of the connectors between the occupant detection control module and the airbag control module.
- Check buckle switch.
- Turn the ignition switch to OFF, disconnect the battery ground terminal, and wait for 60 seconds or more.
- Disconnect the buckle switch connector.
- Connect the test harness AE and the test harness connector Y to the buckle switch connector C.
- Connect the battery ground terminal and turn the ignition switch to ON.
Criteria: The airbag warning light illuminates for 6 seconds, then it goes off.
NG: Check the seat harness, and if any fault is found, repair the harness. In the case that the fault cannot be corrected, replace the front seat ASSY RH.
OK: Replace the front seat inner belt ASSY RH (seat belt buckle switch RH).