LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Occupant Detection System (Diagnostics)) >> Occupant Detection System >> Airbag Connector

Airbag Connector

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. How to disconnect the occupant detection system (between airbag rear harness and seat harness).
    CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.
    1. Push the connector lock arm (B) connected to the connector (A) under the passenger's seat to disconnect the connector.
      Fig 1: Disconnecting Occupant Detection System (Between Airbag Rear Harness And Seat Harness)
      G08557661Courtesy of SUBARU OF AMERICA, INC.
  2. How to connect the occupant detection system (between airbag rear harness and seat harness).
    CAUTION: Be sure to insert the connector in until it is locked. Then pull it gently to make sure that it is locked.
    1. Holding the connector, push it in securely until a clicking sound is heard.
  3. Airbag control module
    1. Refer to "SRS airbag system". (Refer to AIRBAG CONNECTOR )
  4. Buckle switch RH
    1. Refer to "SRS airbag system". (Refer to AIRBAG CONNECTOR )
scientia non olet · About LEMON Manuals