Section 40 (Emission Control System): Canister: Installation

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CHARCOAL CANISTER ASSEMBLY
1. Install the canister bracket B to the charcoal canister assembly with 2 nuts.
  Standard value: T=8.0N.m {82kgf.cm} {5.9ft.lbf}
2. Install the charcoal canister assembly with canister bracket B with the 2 bolts and the nut.
  Standard value: Bolt
  
  T=7.5N.m {76kgf.cm} {5.5ft.lbf}
  
  Nut
  
  T=8.0N.m {82kgf.cm} {5.9ft.lbf}
3. Connect the fuel tank vent tube as indicated by the arrows, in the order shown in the illustration.
  
  Fig 1: Identifying Fuel Tank Vent Tube Connecting Sequence
  Courtesy of SUBARU OF AMERICA, INC.
4. Connect the purge tube as shown in the illustration.
  
  Fig 2: Connecting Purge Tube
  Courtesy of SUBARU OF AMERICA, INC.
INSTALL CANISTER PUMP MODULE
1. Install the drain tube C.
2. Connect the drain tube A and the drain tube B.
3. Engage the clamp.
4. Install the nuts and bracket B.
  Standard value: T=18N.m {184kgf.cm} {13.3ft.lbf}
5. Install the 2 nuts and bracket A.
  Standard value: T=18N.m {184kgf.cm} {13.3ft.lbf}
6. Engage the clip.
7. Install the canister pump module with 3 bolts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
8. Connect the evaporation hose to the fuel pipe assembly.
9. Engage the clip.
10. Connect the drain tube A to the fuel filler pipe.
11. Connect the drain tube B to the charcoal canister assembly.
INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY (Refer to INSTALLATION )
INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY (Refer to INSTALLATION )