LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System -- BRZ >> Cruise Control System >> Cancel Code 11 >> Inspection steps

Inspection steps

  1. Check cruise control main switch circuit.
    1. Remove the driver's airbag module.
    2. Disconnect the cruise control command switch connector.
    3. Turn the ignition switch to ON.
    4. Measure the voltage between connector terminal and chassis ground.

      Voltage

      Inspection terminals Inspection conditions Standard value
      Z5-4 - chassis ground IG ON 5V or more

      NG: Check the roll connector, and repair or replace the harness.

      OK: Go to next step

  2. Check cruise control main switch circuit.
    1. Turn the ignition switch to OFF.
    2. Measure the resistance between connector terminal and chassis ground.

      Resistance (open circuit check)

      RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

      Inspection terminals Inspection conditions Standard value
      Z5-3 - chassis ground Always Less than 10 Ω

      NG: Check ECM and roll connector, and repair or replace the harness.

      OK: Go to next step

  3. Check cruise control main switch circuit.
    1. Measure the resistance when the cruise control main switch is not in operation.

      Resistance (open circuit check)

      RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

      Inspection terminals Inspection conditions Standard value
      Cruise control main switch side connector terminal 3 - cruise control main switch side connector terminal 1 IG ON 1 MΩ or more

      NG: Replace the cruise control main switch.

      OK: Go to next step

  4. Check cruise control main switch circuit.
    1. Measure the resistance when the cruise control ON-OFF switch is pressed.

      Resistance (open circuit check)

      RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

      Inspection terminals Inspection conditions Standard value
      Cruise control main switch side connector terminal 3 - cruise control main switch side connector terminal 1 IG ON Less than 1 Ω

      NG: Replace the cruise control main switch.

      OK: Go to next step

  5. Check cruise control main switch circuit.
    1. Measure the resistance when the CANCEL switch is pressed.

      Resistance (open circuit check)

      RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

      Inspection terminals Inspection conditions Standard value
      Cruise control main switch side connector terminal 3 - cruise control main switch side connector terminal 1 Always Approx. 1540Ω

      NG: Replace the cruise control main switch.

      OK: Go to next step

  6. Check cruise control main switch circuit.
    1. Measure the resistance when the -SET switch is pressed.

      Resistance (open circuit check)

      RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

      Inspection terminals Inspection conditions Standard value
      Cruise control main switch side connector terminal 3 - cruise control main switch side connector terminal 1 Always Approx. 630Ω

      NG: Replace the cruise control main switch.

      OK: Go to next step

  7. Check cruise control main switch circuit.
    1. Measure the resistance when the +RES switch is pressed.

      Resistance (open circuit check)

      RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

      Inspection terminals Inspection conditions Standard value
      Cruise control main switch side connector terminal 3 - cruise control main switch side connector terminal 1 Always Approx. 240Ω

      NG: Replace the cruise control main switch.

      OK: Replace the ECM.

scientia non olet · About LEMON Manuals