Front Sub Sensor: Installation
WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- If the airbag has been activated, replace the front sub sensor with a new part.
- Do not reuse the bolt and nut.
Always replace with the specified new bolts and nuts.
- When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.
- Before installation, inspect the following items and replace any faulty part with a new part.
- Front sub sensor damage
- Connector damage
- Install each part in the reverse order of removal.
Tightening torque:
Front sub sensor: 13 N.m (1.33 kgf-m, 9.6 ft-lb)
Bumper beam COMPL - front: 32 N.m (3.36 kgf-m, 24.3 ft-lb)