Ignition Switch Illumination: Removal

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The ignition switch illumination is integrated into the immobilizer antenna assembly.

Disconnect the ground cable from battery.
Remove the cover assembly - column.
1. Remove the screws by turning the steering wheel to right and left.
  
  Fig 1: Removing Screws By Turning Steering Wheel To Right And Left
  Courtesy of SUBARU OF AMERICA, INC.
2. Release the claw, and remove the cover assembly - column UPR and the cover assembly - column LWR.
  
  Fig 2: Removing Column UPR Cover Assembly
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector and remove the ignition switch illumination.
CAUTION: Do not apply excessive force to remove the ignition switch illumination lock. Otherwise they may be broken because those parts are the products made of a plastic.

Fig 3: Removing Ignition Switch Illumination
Courtesy of SUBARU OF AMERICA, INC.