LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2014 >> Outback 2.5i, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Fuel Injection Fuel Systems (H4DO)) >> Fuel Level Sensor >> Removal

Fuel Level Sensor: Removal

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Place "NO OPEN FLAMES" signs near the working area.
CAUTION:
  • Be careful not to spill fuel.
  • If the fuel gauge indicates that two thirds or more of the fuel is remaining, be sure to drain fuel before starting work to avoid the fuel to spill.
NOTE: The fuel level sensor is built in fuel pump assembly.
  1. Remove the fuel pump assembly. < Ref. to REMOVAL , Fuel Pump. >
  2. Disconnect the fuel level sensor connector (A), and pull out the connector cable and fuel level sensor harness from the clip.
    Fig 1: Locating Fuel Level Sensor Connector
    G09475664Courtesy of SUBARU OF AMERICA, INC.
  3. While pressing the claw (A) of the fuel level sensor, slide the fuel level sensor in the direction of the arrow, and remove the fuel level sensor.
    Fig 2: Sliding Fuel Level Sensor
    G09475665Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals