Camera Initialization
WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
This is a recovery measures prepared for the data failure caused by the low battery voltage during data storage to inside the stereo camera.
CAUTION:
Do not usually perform camera initialization because it will clear the aiming data and/or DTCs.
Perform the camera initialization only when the aiming result is NG even if the vehicle is placed correctly in the flowchart described in "A: Procedure".
- Turn the ignition switch to ON.
- Wait for 10 seconds.
- On Main Menu display, select {Each System Check}.
- On «System Selection Menu», select {ADA adaptive cruise control system}.
- Select «EyeSight (from 2009MY)».
- Select {Clear Memory} while pressing the camera cover mounted pre-collision brake OFF switch and lane departure warning OFF switch at the same time.
- Turn the ignition switch to OFF.
- Wait for 5 seconds.
- Next, perform the clear adjustment value. < Ref. to ADJUSTMENT VALUE CLEAR , PROCEDURE, Camera Adjustment, Inspection. >