LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2014 >> Legacy 2.5i, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Eyesight System (Diagnostics)) >> Camera Adjustment, Inspection >> Procedure >> Automatic Adjustment And Function Check By Driving

Automatic Adjustment And Function Check By Driving

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Perform the automatic adjustment and function check by driving to improve the recognition accuracy of stereo camera, when the stereo camera is replaced or re-adjusted, or the EyeSight function does not operate correctly.
  • The automatic adjustment and function check by driving adjust the stereo camera more in detail, based on the stereo camera adjustment using RANDOM CHART.
  1. Perform this procedure after finishing stereo camera adjustment and inspection.
  2. On «ADA adaptive cruise control system» display, select {EyeSight (from 2009MY)}.
  3. On «EyeSight (from 2009MY)» display, select {Current Data Display & Save}.
  4. On «Current Data Display & Save» display, display the {Automatic adjustment status}. < Ref. to OPERATION , Read Current Data. >
  5. Drive the vehicle until [Automatic adjustment status] displays {1F}.

    Drive the vehicle so that the distance from the preceding vehicle is 40 m or more.

    Display Content Unit of measure Note (at idling)
    Automatic adjustment status Index for automatic adjustment operation performed by the driving test after the completion of the optical axis adjustment - {1F} is displayed when completed.
    NOTE:
    • The time required until {1F} is displayed may be longer depending on the road condition etc.
    • For new vehicles, {00} may be displayed. It is not necessary to drive the vehicle before delivery because high-accuracy aiming has been performed at vehicle shipment.
  6. On {Current Data Display & Save} display, display [Lane recognition status] to check if any of the following appears.
    • Right lane is recognized: 01
    • Left lane is recognized: 10
    • Right and left lane are recognized: 11
    Display Content Unit of measure Note (at idling)
    Lane recognition status Display of lane recognition status - Recognized when vehicle lane can be seen by 20 m or more.
  7. On {Current Data Display & Save} display, display [Distance from leading vehicle] to check if the distance from the preceding vehicle is approximately the same.
scientia non olet · About LEMON Manuals