Generic Scan Tool
- Check that no DTC remains after clearing memory. < Refer to CLEAR MEMORY MODE . >
- Warm up the engine.
- Connect the delivery (test) mode connector (A) located under the glove box.
- Connect the generic scan tool to data link connector located in the lower portion of the instrument panel (on the driver's side).CAUTION: Do not connect the scan tools except for Subaru Select Monitor and generic scan tool.
- Start the engine.NOTE: Depress the clutch pedal when starting engine.
- Turn the neutral position switch to ON by operating shift lever.
- Keep the engine speed in 2, 500 - 3, 000 rpm range for 40 seconds.
- Place the shift lever in 1st gear and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).NOTE:
- For AWD model, release the parking brake.
- The rotating speed difference between front and rear wheels may illuminate the ABS warning light, but this does not indicate a malfunction. When engine control system diagnosis is finished, perform the VDC memory clearance procedure of self-diagnosis function. < Refer to CLEAR MEMORY MODE . >
- Using the generic scan tool, check for DTC and record the result(s).NOTE:
- For detailed operation procedures, refer to the generic scan tool operation manual.
- For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".
< Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >