Yaw Rate and G Sensor: Installation

Install each part in the reverse order of removal.

Tightening torque:

7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

CAUTION: After completion of installation, set the following two positions.

Positioning to the center of steering angle sensor
Positioning the yaw rate & G sensors to zero The above procedure is required VDCCM&H/U to identify the vehicle position afterward. For the setting procedures of the 2 steps above, refer to "VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)". < Refer to ADJUSTMENT , VDC Control Module and Hydraulic Control Unit (VDCCM&H/U). >