LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2014 >> Forester 2.0XT Premium, 4D Utility >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamics Control (Service Information) >> ABS Sequence Control >> Operation >> Abs Sequence Control With SUBARU Select Monitor

Abs Sequence Control With SUBARU Select Monitor

CAUTION: For models with EyeSight, performing the sequence control may cause the EyeSight warning light to illuminate. If the sequence control is performed, refer to "Basic Diagnostic Procedure" of "EyeSight (DIAGNOSTICS)" and check DTCs and then clear memory. < Ref. to BASIC DIAGNOSTIC PROCEDURE . >
NOTE: In the event of any trouble, the ABS sequence control will not operate.
  1. Connect the Subaru Select Monitor to data link connector.
    1. Run the "PC application for Subaru Select Monitor".
    2. On «Main Menu» display, select {Each System Check}.
    3. Select {Brake Control System}. When {VDC} is displayed, select the [OK] button.
    4. Select the {Function Check Sequence} from {Work Support}.
    5. Select the {ABS Sequence Control Mode} from {Function Check Sequence}.
  2. Follow the procedures displayed in the Subaru Select Monitor to execute the following.
    1. When using a brake tester, depress the brake pedal with a force of 100 N (10.2 kgf, 22.5 lbf).
    2. When using a pressure gauge, press the brake pedal so that the pressure gauge indicates 3, 500 kPa (36 kgf/cm2 , 511 psi).
  3. The brake system being operated is displayed on the Subaru Select Monitor.
scientia non olet · About LEMON Manuals