LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Tribeca >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Combination Meter >> Removal

Combination Meter: Removal

  1. Disconnect the ground cable from battery.
  2. Set the tilt steering at the lowest position.
  3. Remove the console box. < Refer to REMOVAL , Console Box. >
  4. Remove the control panel. < Refer to REMOVAL , Control Panel. >
  5. Remove the instrument panel lower cover. < Refer to REMOVAL , Instrument Panel Lower Cover. >
  6. Remove the console side panel. < Refer to REMOVAL , Center Console. >
  7. Remove the meter visor.
  8. Remove the screws of combination meter (two for upper side, two for lower side) and pull the combination meter.
    Fig 1: Identifying Combination Meter Mounting Screws
    G05672094Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the connector in the rear side of combination meter to remove meter.
    CAUTION:
    • Be careful not to damage the meter or instrument panel.
    • Pay particular attention to avoid damaging the meter glass.
scientia non olet · About LEMON Manuals