LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls (Diagnostics) (H4DO)) >> Drive Cycle >> Procedure >> Preparation For Drive Cycle

Preparation For Drive Cycle

WARNING: This page is about a different variant/trim than selected.
  1. Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
  2. After performing the diagnostics and Clear Memory Mode, check that no DTC remains. Refer to CLEAR MEMORY MODE .
    NOTE: Perform the drive cycle after warming up the engine except when the engine coolant temperature at engine start is specified.
scientia non olet · About LEMON Manuals