Front Brake Hose

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Secure the brake hose to strut mount.
Tightening torque:

33 N.m (3.36 kgf-m, 24.3 ft-lb)
Install the brake hose to the caliper body using a new gasket.
Tightening torque (union bolt):

18 N.m (1.84 kgf-m, 13.3 ft-lb)

Fig 1: Identifying Brake Hose Union Bolt
Courtesy of SUBARU OF AMERICA, INC.
Position the disc in straight position and route the brake hose through the hole in the bracket on the wheel apron side.
CAUTION:
Do not twist the brake hose.
Temporarily tighten the flare nut which connects brake pipe and hose.
Secure the brake hose to wheel apron bracket with clamp.
Tighten the flare nut to the specified torque.
Tightening torque (brake pipe flare nut):

15 N.m (1.53 kgf-m, 11.1 ft-lb)
Bleed air from the brake system. < Refer to PROCEDURE , Air Bleeding. >