Drive Pinion Shaft Assembly: Disassembly

Flatten the tab of the lock nut.
Using ST1, ST2 and ST3, fix at the spline portion of drive pinion shaft to remove the lock nut.
ST1 499787500 ADAPTER

ST2 499787700 WRENCH

ST3 498937110 HOLDER

Fig 1: Removing Drive Pinion Shaft Assembly Lock Nut Using Special Tools
Courtesy of SUBARU OF AMERICA, INC.
Remove the drive pinion shaft from the drive pinion retainer.

Fig 2: Identifying Drive Pinion Shaft
Courtesy of SUBARU OF AMERICA, INC.
Using the round bar with diameter of 36 mm (1.42 in) or 37 mm (1.46 in), remove the bearing inner race and plug.

Fig 3: Removing Bearing Inner Race And Plug Using Round Bar
Courtesy of SUBARU OF AMERICA, INC.
Remove the drive pinion washer.
Remove the drive pinion spacer.

Fig 4: Identifying Drive Pinion Spacer
Courtesy of SUBARU OF AMERICA, INC.
Remove the O-ring.

Fig 5: Locating Drive Pinion Shaft Assembly O-Ring
Courtesy of SUBARU OF AMERICA, INC.
Remove the inner race and drive pinion shim from drive pinion shaft using ST.
ST 498515500 REMOVER

Fig 6: Removing Inner Race And Drive Pinion Shim From Drive Pinion Shaft Using Special Tool
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, remove the outer race.
ST 398527700 PULLER ASSY

Fig 7: Removing Outer Race Using Puller Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the two oil seals using a screwdriver wrapped with cloth etc.
CAUTION: Do not damage the fitting surface of oil seal.

Fig 8: Identifying Oil Seals
Courtesy of SUBARU OF AMERICA, INC.
Remove the plug from drive pinion retainer.

Fig 9: Locating Drive Pinion Retainer Plug
Courtesy of SUBARU OF AMERICA, INC.