Master Cylinder: Removal

Disconnect the ground cable from battery.
Thoroughly drain the clutch fluid from the reservoir tank.
Remove the instrument panel lower cover. Refer to REMOVAL .
Remove the pedal assembly. Refer to REMOVAL .
Remove the clip and clevis pin, and then separate the push rod of the master cylinder from clutch pedal.

Fig 1: Identifying Clevis Pin, Push Rod And Clip
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the clutch stroke sensor connector.
Remove the clutch pipe from the master cylinder.

Fig 2: Locating Clutch Pipe Nuts
Courtesy of SUBARU OF AMERICA, INC.
Remove the master cylinder from the pedal bracket.

Fig 3: Locating Master Cylinder Nuts
Courtesy of SUBARU OF AMERICA, INC.