Outer Belt RH Assembly & LH Assembly (Outback Model)

CAUTION: If the hook is disconnected from the vehicle body, replace the hook with the new part to prevent the decline of the fixed force of the seat.

Fig 1: Identifying Rear Seat Cushion

Courtesy of SUBARU OF AMERICA, INC.

Before installation, perform a unit inspection of retractor. < Refer to INSPECTION , Rear Seat Belt. >
Install the outer seat belt retractor.
Tightening torque:

Rear seat belt (OUTBACK model): < Refer to REAR SEAT BELT (OUTBACK MODEL) , COMPONENT, General Description. >
Install the rear quarter trim UPR.
Install the outer belt shoulder anchor.
Install the outer belt lower anchor.
CAUTION:
- During installation, make sure that the seat belts are not twisted.
- After installation, make sure that the seat belts are smoothly extended and wound.
Tightening torque:

Rear seat belt (OUTBACK model): < Refer to REAR SEAT BELT (OUTBACK MODEL) , COMPONENT, General Description. >
Install the remaining parts in the reverse order of removal.
After installation, check the following points.
- The seat belt is not twisted.
- The seat belt can be pulled out and retracted smoothly.