LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Continuously Variable Transaxle (CVT)) >> Secondary Pressure Sensor >> Removal

Secondary Pressure Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
  • When secondary pressure sensor is removed, CVTF leaks. After installing the secondary pressure sensor, adjust the CVTF level.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the secondary pressure sensor connector.
  4. Remove the secondary pressure sensor.
    Fig 1: Identifying Secondary Pressure Sensor
    G08317807Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals