LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Continuously Variable Transaxle (CVT)) >> Inhibitor Switch >> Removal

Inhibitor Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Shift the select lever to "N" range.
  2. Disconnect the ground cable from battery.
  3. Lift up the vehicle.
  4. Remove the center exhaust pipe. Refer to REMOVAL .
  5. Remove the snap pin and washer from the shifter arm.
    Fig 1: Identifying Shifter Arm, Snap Pin, Select Cable And Washer
    G08578691Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the spring pin and shifter arm.
    Fig 2: Identifying Spring Pin And Shifter Arm
    G08578692Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the inhibitor harness connector from inhibitor switch.
  8. Remove the two inhibitor switch securing bolts.
    Fig 3: Identifying Inhibitor Switch With Securing Bolts
    G08317792Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the inhibitor switch from the transmission case.
scientia non olet · About LEMON Manuals