LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Intake System (Induction) (H6DO)) >> Air Intake Boot >> Removal

Air Intake Boot: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow the steps below when removing the collector cover.
    1. Pull up the two points at the rear (A).
    2. Pull up the two points at the front (B) while moving them forward.
    Fig 1: Pulling Up Air Intake Boot Collector Lever
    G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Loosen the clamp which connects the air intake boot assembly and air cleaner case (rear).
    Fig 2: Locating Clamp Connecting Air Intake Boot Assembly And Air Cleaner Case (Rear)
    G06651459Courtesy of SUBARU OF AMERICA, INC.
  3. Loosen the clamp (A) which connects the air intake boot assembly and throttle body.
  4. Loosen the bolt (B) which secures the air intake boot assembly and collector cover bracket.
    Fig 3: Identifying Air Intake Boot Assembly And Throttle Body Connecting Clamp
    G08582852Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the blow-by hose and remove the air intake boot assembly.
scientia non olet · About LEMON Manuals