LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Continuously Variable Transaxle (CVT) (Diagnostics)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P1724 At EEPROM Error >> Trouble Symptom

DTC P1724 At EEPROM Error: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK TCM CONNECTOR.  Is the connection of TCM connector correct? Go to step 2  . Connect the TCM connector.
2 CHECK SELF SHUT RELAY. 
Turn the ignition switch to ON.		 Does the relay operates simultaneously? Go to step 3  . Perform the diagnosis according to DTC P0890.
3 CHECK SELF SHUT RELAY. 
Turn the ignition switch to OFF.		 Does the relay operate after two or three seconds delay? Go to step 4  . Perform the diagnosis according to DTC P0890.
4 PERFORM AT LEARNING. 
  1. Clear the AT learning value.
  2. Perform the AT learning. Refer to LEARNING CONTROL .
  3. Start the engine.
 Does the AT OIL TEMP light blink after AT learning is finished correctly? Check the TCM. Go to step 5  .
5 CHECK FOR ANY OTHER DTC ON DISPLAY. 
  1. Perform «Clear Memory».
  2. Turn the ignition switch to OFF.
  3. Start the engine after 10 seconds.
  4. Repeat steps 2) and 3).
 Does the AT OIL TEMP light blink and is DTC P1724 displayed? Check the TCM. Current condition is normal. Check for poor contact of TCM connector or harness.
scientia non olet · About LEMON Manuals