LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Occupant Detection System (Diagnostics)) >> Subaru Select Monitor >> Operation

Subaru Select Monitor: Operation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit. < Refer to SPECIAL TOOL , PREPARATION TOOL, General Description. >
  2. Connect the diagnosis cable to Subaru Select Monitor.
  3. Connect the Subaru Select Monitor to data link connector.
    1. Data link connector is located in the lower portion of instrument panel (on the driver's side).
      Fig 1: Identifying Data Link Connector Location
      G05663967Courtesy of SUBARU OF AMERICA, INC.
    2. Connect the diagnosis cable to data link connector.
    CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
  4. Turn the ignition switch to ON and run the Subaru Select Monitor.
scientia non olet · About LEMON Manuals