DTC 29 ODS Failure: DTC Detecting Condition
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Occupant detection sensor is faulty.
- Occupant detection control module is faulty.
- Occupant detection harness is faulty.
- Rear airbag harness is faulty.
- Fuse No. 25 (in joint box) is blown.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK POOR CONTACT OF CONNECTORS. Check for poor contact of the connectors between the occupant detection control module and airbag control module. |
Is there poor contact? | Reconnect the connector. If the fault is not fixed, replace the airbag harness. | Go to step 2 . |
| 2 CHECK DIAGNOSTIC TROUBLE CODE (DTC). Read diagnostic trouble code (DTC) for the airbag system. |
Is "2C Belt Tension Sensor Failure or 37 Buckle Switch Failure" displayed in the diagnostics code? | Perform the diagnosis according to each DTC. | Check the seat harness, and if any fault is found, replace the seat harness. If the fault is not fixed, replace the occupant detection system. < Refer to PASSENGER'S SEAT , DISASSEMBLY, Front Seat. > |