LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks - Keyless Access (W/Push Button Start) (Diagnostics) >> Diagnostics with Phenomenon >> Inspection >> All Keyless Access Functions Do Not Operate

All Keyless Access Functions Do Not Operate

CAUTION:
  • Inspect LAN system according to the basic diagnostic procedure, and make sure that there is no fault.
  • Check that the keyless access function is not stopped.
  • When the access key or keyless access CM is replaced, registration of the immobilizer is required. For the relevant procedures, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".
Step Check Yes No
1 CHECK KEYLESS ACCESS FUNCTION STOP. 
Check for whether the keyless access system is in a stop status or simple cancel function status. < Refer to OPERATION , Function Setting (Customize). >		 Is the keyless access system in a stop status? Release the keyless access function stop status. < Refer to OPERATION , Function Setting (Customize). > Go to step 2  .
2 CHECK KEYLESS ACCESS CM. 
  1. Disconnect the keyless access CM connector.
  2. Using a tester, measure the voltage between the keyless access CM connector and chassis ground.

    Connector & terminal 

    (B572) No. 2 (+) - Chassis ground (-): 

 Is the voltage 10 V or more? Go to step 3  . Repair or replace the open circuit of harness.
3 CHECK KEYLESS ACCESS CM. 
Using a tester, check continuity between the keyless access CM connector and chassis ground.
Connector & terminal 
(B572) No. 11 - Chassis ground: 		 Is there continuity? Replace the keyless access CM. < Refer to KEYLESS ACCESS CM . > Repair or replace the open circuit of harness.
scientia non olet · About LEMON Manuals