LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Keyless Entry System >> Inspection >> Check Room Light Operation

Check Room Light Operation

Step Check Yes No
1 CHECK ROOM LIGHT OPERATION. 
Make sure the room light illuminates when the room light switch is ON, and goes off when the switch is OFF.		 Does the room light illuminate or go off? Go to step 2  . Check the room light circuit. Refer to INSPECTION .
2 CHECK ROOM LIGHT OPERATION. 
  1. Turn the room light switch to the "DOOR" position.
  2. Open and close any door.
 Does the room light illuminate ↔ go off (including off delay) when the door is opened and closed? Go to step 3  . Go to step 4  .
3 CHECK KEYLESS ENTRY OPERATION. 
Press the LOCK/UNLOCK button of the keyless transmitter.		 Does it operate properly? Room light is normal. Check keyless entry system. Refer to SYMPTOM CHART .
4 CHECK ROOM LIGHT. 
  1. Disconnect the room light connector.
  2. Check the room light. Refer to INSPECTION .
 Is room light normal? Go to step 5  . Replace the bulb or room light assembly.
5 CHECK HARNESS. 
  1. Disconnect the body integrated unit connector.
  2. Check the harness between body integrated unit connector and room light connector.

    Connector & terminal 

    (i84) No. 4 - (R52) No. 2: 

 Is harness normal? Go to step 6  . Repair or replace the harness.
6 CHECK HARNESS. 
Measure the voltage between room light connector and chassis ground.
Connector & terminal 
(R52) No. 3 (+) - Chassis ground (-): 		 Is the voltage 10 V or more? Replace the body integrated unit. Refer to BODY INTEGRATED UNIT . Repair or replace the harness.
scientia non olet · About LEMON Manuals