LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Entertainment System >> AUX Input Terminal >> Removal >> Aux Terminal Harness

Aux Terminal Harness

  1. Disconnect the ground cable from battery.
  2. Remove the console front cover assembly.
    • MT model
      1. Remove the shift knob.
      2. Release the clips and claws, then pull up the console front cover assembly.
        Fig 1: Removing Console Front Cover Assembly (MT Model)
        G06653100Courtesy of SUBARU OF AMERICA, INC.
        NOTE: Turn over the front center pocket mat (a) and pull up the console front cover from the slit.
      3. Disconnect the harness connector and remove the console front cover assembly.
    • AT/CVT model
      1. Remove the select lever knob.
        1. Lower the cover grip AT.
        2. Remove the clamp grip pin, then remove the select lever knob.
      2. Release the clips and claws, then pull up the console front cover assembly.
        Fig 2: Pulling Up Console Front Cover Assembly
        G06653101Courtesy of SUBARU OF AMERICA, INC.
        NOTE: Turn over the front center pocket mat (a) and pull up the console front cover from the slit.
      3. Disconnect the harness connector and remove the console front cover assembly.
  3. Remove the console front side cover assembly LH.
    1. Remove the screws and release the clips (A) to (D) in order.
    2. Remove the console front side cover assembly by pulling it up.
      Fig 3: Removing Console Front Side Cover Assembly
      G06653660Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the center panel assembly.
    CAUTION: Do not put your finger on the fin of the air vent grille. Doing so may damage the fin.
    1. Attach the protective tape (a) to the meter visor.
      Fig 4: Identifying Protective Tape On Meter Visor
      G08348677Courtesy of SUBARU OF AMERICA, INC.
    2. Insert a finger into the air vent grille and release the left and right clips at the top of the center panel. (A), (B)
    3. Insert a finger into the air vent grille and release the left and right clips at the center of the center panel. (C), (D)
    4. Release the clips at the bottom of the center panel and remove the center panel assembly.
      Fig 5: Removing Center Panel Assembly
      G08348678Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the audio assembly.
    1. Remove the left and right screws, and partially pull the audio out from center console.
    2. Disconnect the connectors, and remove the audio assembly.
      Fig 6: Locating Audio Assembly Mounting Screws
      G08348679Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the navigation assembly. (model with navigation)
    1. Remove the left and right screws.
    2. Disconnect the connectors, and remove the navigation assembly.
      Fig 7: Locating Navigation Assembly Mounting Screws
      G08583826Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the AUX terminal harness.
    1. Remove the harness clamp.
    2. Disconnect the connector from the AUX input terminal assembly, and remove the AUX terminal harness.
      Fig 8: Locating Auxiliary Terminal Harness Connector And Clamps
      G06653665Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals