User Customizing: Operation

On «Main Menu» display, select {Each System Check}.
On «System Selection Menu» display, select {Integ. unit mode}.
On «Integ. unit mode failure diag.» display, select {Unit customizing}.

Change the setting with UP/DOWN key and set with the [OK] key.

List of User Customizing item

Data	Initial setting value	Customize setting	Remarks
Off delay time	Long		Delay time below can be selected by setting.
		OFF	0 seconds
		Short	10 seconds
		Normal	20 seconds
		Long	30 seconds
Auto Light Sensitivity Adjustment	Normal	Dull	Slow response
		Normal	Standard
		Sensitive	Quick response
		Very sensitive	Fairly quick response
Rr defogger op. mode	Normal	Normal	Automatically stops in 15 minutes after switch is turned to ON.
Rr defogger op. mode	Normal	Continuous	Repeats active condition for 15 minutes and inactive condition for 2 minutes until switch is turned to OFF.
Security Alarm Setup	ON	ON	Security alarm (hazard, horn or siren) in active condition
Security Alarm Setup	ON	OFF	Security alarm in inactive condition
Impact Sensor Setup	OFF	ON	Workable when Impact Sensor Setup is set to "ON". Impact sensor function becomes activated.
Impact Sensor Setup	OFF	OFF	Impact sensor in inactive condition (Set to "OFF" in models without sensors.)
Alarm delay setup	ON		After the keyless lock operation, the alarm monitor starts after the following delay time has passed.
		ON	Delay time is 30 seconds.
		OFF	Delay time is 0 seconds.
Lockout prevention	ON	ON	key lockout prevention function is activated. (The function does not operate if safety knob is locked by hand.)
Lockout prevention	ON	OFF	Key lockout prevention function is deactivated.
Impact sensor (OP)	OFF	ON	Vehicle is controlled in impact sensor equipped mode. (Make sure to set to "OFF" for models without the impact sensor. When "ON", hazard, horn or siren become activated by keyless lock (alarm monitor start).)
Impact sensor (OP)	OFF	OFF	Vehicle is controlled in no impact sensor mode.
Answer-back buzzer setup	ON	ON	When lock/unlock is selected by keyless entry system operation, buzzer operates.
Answer-back buzzer setup	ON	OFF	When lock/unlock is selected by keyless entry system operation, buzzer does not operate.
Hazard answer-back setup	ON	ON	When lock/unlock is selected by keyless entry system operation, hazard blinks.
Hazard answer-back setup	ON	OFF	When lock/unlock is selected by keyless entry system operation, hazard does not interlock.
Initial keyless setting	-	-
Initial keyless setting	-	Execution
Initial button setting	-	-
Initial button setting	-	Execution
Select unlock switch	ALL	ALL	All doors are unlocked by one unlock signal.
Select unlock switch	ALL	Selection	All doors are unlocked by two unlock signals.
Passive Alarm	OFF	ON
Passive Alarm	OFF	OFF
Door open warning	ON	ON
Door open warning	ON	OFF
Dome Light Alarm Setting	OFF	ON	Room light illuminates interlocking with alarm.
Dome Light Alarm Setting	OFF	OFF	Room light does not illuminate interlocking with alarm.
Belt Warning Switch	ON	ON	Belt warning buzzer beeps.
Belt Warning Switch	ON	OFF	Belt warning buzzer stops.

After setting, make sure that the setting changed in the {Current Data Display & Save} is same as vehicle equipment.
CAUTION:
- the above settings must match the actual vehicle equipment.
- Do not change settings except for setting above while setting the functions.
- Be sure not to change Factory initial setting except when installing a new body integrated unit.
NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".