LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Impact Sensor >> Operation >> Impact Sensor Setting Using SUBARU Select Monitor

Impact Sensor Setting Using SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit.
  2. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  3. On «System Selection Menu» display, select {Integ. unit mode}.
  4. Select {Unit customizing}.
  5. Make an impact monitor setting.
    • When installing: ON
    • When removing: OFF
  6. Make a impact monitor ON/OFF setting.
    • When installing: ON
    • When removing: OFF
  7. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
scientia non olet · About LEMON Manuals