LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Function Setting (Customize) >> Procedure

Function Setting (Customize): Procedure

  1. Check that the vehicle status is as follows:
    • Ignition switch OFF
    • One window is completely open
    • Keyless access system is activated (or disabled if re-activating)
  2. Sit in the driver's seat with the door closed and press the door lock switch to UNLOCK once.
  3. Open the driver's door within five seconds.
  4. Within 5 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
  5. Within 30 seconds, perform the closing → opening operation of the driver's door twice.
  6. Within 30 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
  7. Within 30 seconds, perform the closing → opening operation of the driver's door once.
  8. Within five seconds, close the driver's door.
    • The access buzzer sounds once (long sound) to indicate that the keyless access system is disabled (when the system is already disabled, the buzzer sounds once shortly to indicate that it is activated).
    NOTE:
    • Perform the same procedures to re-activate the keyless access system from the disabled condition.
    • If the driver's door is opened or closed in step  4) or step  6), the cancel operation is disabled.
scientia non olet · About LEMON Manuals