LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> LAN Communication System (Diagnostics) >> CAN Communication Circuit Check >> Procedure >> Bus "A" (Main-Can) >> Notes

Bus "A" (Main-Can): Notes

NOTE:
  • When measuring the resistance of CAN communication circuit, measure it in sleep status. To enter sleep status.
    • With ignition switch OFF and key or switch operation stopped, keep the doors, trunk, and rear gate all closed for one minute or more.
    • On models with keyless access function, keep the access key 2 m or more away from the vehicle.
  • When the bus line is measured, combined resistance of the end resistance (120 O) in ECM and the end resistance (120 O) in VDC CM can be measured. The combined resistance is supposed to be approximately 56 - 64 O with the stabilizing circuit included. If the measured resistance value becomes 55 O or less, main wiring harness or related lines may be shorted. Or, the combined resistance may have changed because of a resistance other than the end resistance created on the circuit. If the measured value is 65 O or more, there may be a malfunction such as open circuit in one of the end resistances, or in the stabilizing circuit, or in the main wiring harness.

    Also, even when the resistance value falls within approx. 56 - 64 O, related lines may be open if an error of communication for initializing or a CAN system U-code has occurred. (The resistance won't be between approx. 56 - 64 O if the main wiring harness is open.)

scientia non olet · About LEMON Manuals