DTC C0075 Repair Information (06-80-20)

Publication date: 2020-10-08
Reference number: 06-80-20

DTC C0075 REPAIR INFORMATION

TECHNICAL SERVICE BULLETIN

Reference Number(s): 06-80-20, Date of Issue: October 08, 2020

SUBARU:

2013-14 Legacy and Outback; 2015 Impreza, Crosstrek

APPLICABILITY

2013-14MY Legacy and Outback

2015MY Impreza

2015MY Crosstrek

INTRODUCTION

This bulletin announces a change to the internal logic of the ABS/VDC Hydraulic Control Unit. The change was made to address isolated concerns of the ABS and/or VDC warning lamp(s) coming on in error and setting a DTC C0075: <WHEEL CYLINDER PRESSURE SENSOR OUTPUT> in memory. A logic change was made to optimize the failure detection criteria. The repair involves replacement of the ABS/VDC Hydraulic Control Unit as the unit's software cannot be reprogrammed.

PART INFORMATION

REMINDER: Always order the most up-to-date replacement parts based on the specific VIN being repaired.

Description	Part Number	Application
HYDRAULIC UNIT ASSY V/CONT	27596AJ04C	2013-14MY Legacy/Outback
HYDRAULIC UNIT ASSY V/CONT	27596FJ231	2015MY Impreza/Crosstrek

SERVICE PROCEDURE/INFORMATION

REMINDER: Customer satisfaction and retention starts with performing quality repairs.

VERY IMPORTANT: Service Manual diagnosis for C0075 MUST be completed to rule out other possible cause(s) for the DTC BEFORE replacing the ABS/VDC Hydraulic Control Unit.

The service procedures for replacing the ABS/VDC Hydraulic Control Unit remain unchanged. Always refer to the applicable Service Manual and review the full requirements of the repair being performed. The Service Manual procedures contain information critical to performing an effective repair the first time, every time. This includes but is not limited to important SAFETY precautions, proper inspection criteria, necessary special tools, required processes needed for a complete and lasting repair.

WARRANTY/CLAIM INFORMATION

For vehicles within the Basic New Car Limited Warranty period or covered by an active Subaru Added Security Classic or Gold plan, this repair may be submitted using the following claim information:

Labor Description	Labor Operation #	Labor Time	Fail Code
ABS/VDC HYDRAULIC CONTROL UNIT R&R	B536-301	1.2	QCP-42
ABS/VDC SYSTEM TESTING & DIAGNOSIS	C566-300	0.5	QCP-42

IMPORTANT REMINDERS:

SOA strongly discourages the printing and/or local storage of service information as previously released information and electronic publications may be updated at any time.
Always check for any open recalls or campaigns anytime a vehicle is in for servicing.
Always refer to STIS for the latest service information before performing any repairs.