LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Fuel Injection System (H6DO)) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow these procedures for removal of the collector cover.
    1. Lift up the rear side holding two positions (A).
    2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Drain engine coolant. Refer to DRAINING OF ENGINE COOLANT .
  4. Disconnect the connectors from the engine coolant temperature sensor.
    Fig 2: Locating Engine Coolant Temperature Sensor Connector
    G06651227Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals