LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Automatic Transaxle) >> Drive Pinion Shaft Assembly >> Removal

Drive Pinion Shaft Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. Refer to REMOVAL .
  2. Pull out the torque converter assembly. Refer to REMOVAL .
  3. Remove the transmission harness connector from stay.
  4. Remove the ATF cooler inlet pipe and outlet pipe. Refer to REMOVAL .
  5. Separate the converter case and transmission case. Refer to REMOVAL .
  6. Remove the drive pinion shaft mounting bolts, and then remove the drive pinion shaft assembly from oil pump cover.
    Fig 1: Identifying Oil Pump Cover
    G05022351Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the oil pump cover from AT main case. Refer to OIL PUMP COVER .
scientia non olet · About LEMON Manuals