LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Diagnostics) (H4DO) >> Drive Cycle >> Procedure >> Drive Cycle E >> Diagnostic procedure

Diagnostic procedure

  1. Make sure that the battery voltage is 10.9 V or more.
  2. Perform the Clear Memory Mode. Refer to CLEAR MEMORY MODE .
  3. Drive for approximately 30 L (7.9 US gal, 6.6 Imp gal) of fuel.
    NOTE:
    • It is acceptable to drive the vehicle intermittently.
    • Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)
  4. Read the temporary code using the Subaru Select Monitor or general scan tool. Refer to OPERATION .
scientia non olet · About LEMON Manuals