DTC B16EE ODS Calibration Error: DTC Detecting Condition
- Calibration of occupant detection control module is initial setting or faulty.
- Occupant detection control module is faulty.
DIAGNOSTIC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC. Read the DTC of the airbag system using the Subaru Select Monitor. |
Is another DTC detected? | Perform the diagnosis according to the displayed DTC. | Go to step 2 . |
| 2 PERFORM RE-ZEROING. Perform system calibration using the Subaru Select Monitor. Refer to SYSTEM CALIBRATION (REZEROING) . |
Did the system calibration complete properly? | Go to step 3 . | Replace the occupant detection system. Refer to PASSENGER'S SEAT . |
3 CHECK DTC.
|
Is a DTC other than DTC B16EE displayed? | Perform the diagnosis according to the displayed DTC. | When the DTC is B16EE, replace the occupant detection system. Refer to PASSENGER'S SEAT . When DTC is not displayed, end the diagnosis. |
CAUTION:
When a DTC other than DTC B16EE is present, system calibration (re-zeroing) cannot be completed normally.
When occupant detection system DTC other than DTC B16EE is present, perform the diagnosis of the DTCs other than DTC B16EE.
When occupant detection system DTC other than DTC B16EE is present, perform the diagnosis of the DTCs other than DTC B16EE.