Oil Pump Housing: Removal
- Remove the transmission assembly from the vehicle. < Refer to
REMOVAL , Automatic Transmission Assembly. >
- Pull out the torque converter clutch assembly. < Refer to
REMOVAL , Torque Converter Clutch Assembly. >
- Remove the input shaft.
Courtesy of SUBARU OF AMERICA, INC.
- Lift up the lever on the rear side of transmission harness connector, and then remove it from the stay.
- Remove the inhibitor switch connector from the stay.
- Remove the oil charge pipe. < Refer to
REMOVAL , Oil Charge Pipe. >
- Remove the ATF cooler inlet pipe and outlet pipe. < Refer to
REMOVAL , ATF Cooler Pipe and Hose. >
- Separate the converter case and transmission case. < Refer to
REMOVAL , Converter Case. >
- Separate the transmission case and extension case section. < Refer to
REMOVAL , Extension Case. >
- Remove the reduction drive gear. < Refer to
REMOVAL , Reduction Drive Gear. >
- Remove the reduction driven gear. < Refer to
REMOVAL , Reduction Driven Gear. >
- Loosen the oil pump housing mounting bolts.
Courtesy of SUBARU OF AMERICA, INC.
- Place two wooden blocks on the workbench, and stand the transmission case with the rear end facing down.
NOTE:
- Be careful not to scratch the rear mating surface of the transmission case.
- Check the height of the wooden blocks to avoid damaging the parking rod and drive pinion that are protruding from the mating surface.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the oil pump housing and adjusting thrust washer.
Courtesy of SUBARU OF AMERICA, INC.