Section 53 (Emission Control System): Canister: Installation

WARNING: This page is about a different car, the 2018 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CHARCOAL CANISTER ASSEMBLY

Install the canister bracket B to the charcoal canister assembly with 2 nuts. Standard value: T=8.0N.m {82kgf.cm} {5.9ft.lbf}
Install the charcoal canister assembly with canister bracket B with the 2 bolts and the nut. Standard value: Bolt
T=7.5N.m {76kgf.cm} {5.5ft.lbf}

Nut

T=8.0N.m {82kgf.cm} {5.9ft.lbf}

Connect the fuel tank vent tube as indicated by the arrows, in the order shown in the illustration.

Courtesy of SUBARU OF AMERICA, INC.

Connect the purge tube as shown in the illustration.

Courtesy of SUBARU OF AMERICA, INC.

INSTALL CANISTER PUMP MODULE
1. Install the drain tube C.
2. Connect the drain tube A and the drain tube B.
3. Engage the clamp.
4. Install the nuts and bracket B.
  Standard value: T= 18N.m {184kgf.cm} {13.3ft.lbf}
5. Install the 2 nuts and bracket A.
  Standard value: T= 18N.m {184kgf.cm} {13.3ft.lbf}
6. Engage the clip.
7. Install the canister pump module with 3 bolts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
8. Connect the evaporation hose to the fuel pipe assembly.
9. Engage the clip.
10. Connect the drain tube A to the fuel filler pipe.
11. Connect the drain tube B to the charcoal canister assembly.
Refer to REAR SUSPENSION MEMBER SUB-ASSEMBLY INSTALLATION .
Refer to REAR DIFFERENTIAL CARRIER ASSEMBLY INSTALLATION .