LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Lighting System (Exterior)) >> Lighting System >> Customize Function

Customize Function

WARNING: This page is about a different car, the 2018 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Customize the lighting system (exterior)
    1. Customization using the SSM4
      1. Connect the SSM4 to the DLC3 and turn the ignition to IG ON.
      2. From the SSM4 display screen, select [Each System] →[Body Control] →[Customize] → "each item" to customize the settings.
        Display name Initial setting Contents Setting Controller ECM
        [Light Auto OFF Delay] 30 s Setting of lighting time for light auto cut function OFF, 30 s, 60 s or 90 s Main body ECM (multiplex network body computer)
        [Welcome Light Off Delay Time (Approaching)] 30 s Setting of lighting time for welcome light function (entering the vehicle) OFF, 30 s, 60 s or 90 s
        [Auto Dimmer Cancel Setting] 3 Setting of auto dimmer cancel function 0 (OFF)/stage 1 (least sensitive)/stage 2 (less sensitive)/stage 3 (standard)/stage 4 (more sensitive)/stage 5 (very sensitive)
        [Wiper Link Auto Light Setup] ON Switching of auto light function linked to wipers ON/OFF ON or OFF
        [Lane Change Signal Setting] ON Switching of lane change signal function ON/OFF ON or OFF
        [Auto Light Sensitivity] ±0% Auto light control sensor sensitivity (illumination detection) adjustment function settings (The higher the set value, the easier the light turns on) -40%/-20%/±0%/+20%/+40%
        [DRL Function] ON ON/OFF of the DRL function ON or OFF
        CAUTION: Items without settings are not displayed in the SSM4 or do not function.
scientia non olet · About LEMON Manuals