LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Tribeca Limited >> Repair and Diagnosis >> Steering >> Power Steering >> Power Assisted System Power Steering >> Tilt Steering Column >> Installation

Tilt Steering Column: Installation

  1. Insert the end of the steering shaft into the toe board.
  2. With the tilt lever secured, tighten the steering shaft mounting bolts under instrument panel.

    Tightening torque: 20 N.m (2.0 kgf-m, 14.8 ft-lb) 

  3. Connect all the connectors under the instrument panel.
  4. Connect the airbag system connector at the harness spool.
    NOTE: Make sure to apply double lock.
  5. Install the instrument panel lower cover with tilt lever held in the lowered position.
  6. Install the universal joint. Refer to INSTALLATION , Universal Joint.
    CAUTION:
    • Always install the universal joint after installing the steering column to avoid damage to the universal joint.
    • Be sure to follow the tightening order and tightening torque of universal joint to avoid the steering effort from becoming heavy.
  7. Align the center position of the roll connector. Refer to ROLL CONNECTOR ADJUSTMENT, Roll Connector.
  8. Install the steering wheel. Refer to INSTALLATION , Steering Wheel.
CAUTION: Insert the roll connector guide pin into the guide hole on lower end of steering wheel surface to prevent damage.
scientia non olet · About LEMON Manuals