Front Hub Unit Bearing: Installation
- Place the disc cover between front housing and front hub unit, and tighten the four bolts.
Tightening torque:
65 N.m (6.6 kgf-m, 47.9 ft-lb)
- Install the front drive shaft. Refer to INSTALLATION , Front Drive Shaft.
- Tighten the axle nut temporarily.
- Install the disc rotor to hub.
- Install the disc brake caliper to the front housing.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)
- While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.
Tightening torque:
240 N.m (24.5 kgf-m, 177 ft-lb)
CAUTION:- Install the wheel after installation of axle nut. Failure to follow this rule may damage the wheel bearing.
- Be sure to tighten the axle nut to specified torque. Do not overtighten it as this may damage the wheel bearing.
- After tightening the axle nut, lock it securely.
- Install the front wheel and tighten the wheel nuts to specified torque.
Tightening torque:
Chromed wheel
150 N.m (15.3 kgf-m, 110.6 ft-lb)
Other than above
120 N.m (12.2 kgf-m, 88.5 ft-lb)