1 CHECK REAR GATE RELEASE ACTUATOR OPERATION.
- Turn the ignition switch to OFF.
- Disconnect the key warning switch harness connector.
- Prepare the Subaru Select Monitor kit.
- Turn the ignition switch to ON (engine OFF), and run the "Application for Subaru Select Monitor III".
- On the System Selection Menu, select the {Integ. Unit mode}.
- Select the {Current Data Display & Save}.
- Check the rear gate release output signal of body integrated unit when operating the LOCK/UNLOCK button of keyless transmitter.
|
Is output signal is present when operating the transmitter LOCK/UNLOCK button? |
Go to step 2. |
Check the body integrated unit. Refer to BASIC DIAGNOSTIC PROCEDURE
Basic Diagnostic Procedure. |
2 CHECK CIRCUIT OF REAR GATE RELEASE ACTUATOR.
- Disconnect the harness connector of body integrated unit (i84).
- Disconnect the rear gate release actuator harness connector (D140).
- Measure the resistance between harness connectors.
Connector & terminal
(i84) No. 22 - (D140) No. 1: |
Is the resistance less than 10 Ω? |
Go to step 3. |
Repair the harness. |
3 CHECK CIRCUIT OF HAZARD LIGHT.
- Check the ground circuit of rear gate release actuator
- Disconnect the rear gate release actuator harness connector (D140).
- Measure the resistance between harness connector terminal and chassis ground.
Connector & terminal
(D140) No. 2 - Chassis ground: |
Is the resistance less than 10 Ω? |
Check the rear gate lock actuator. Refer to
INSPECTION , Rear Gate Latch Assembly. |
Repair the harness. |