System Operation Check Mode: Operation: Notes

Prepare the Subaru Select Monitor kit. Refer to PREPARATION TOOL , General Description.

Fig 1: Identifying Subaru Select Monitor Kit
Courtesy of SUBARU OF AMERICA, INC.
Prepare PC with Subaru Select Monitor installed.
Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Select Monitor) using a USB cable.
NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
Connect the diagnosis cable to SDI.
Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).

Fig 2: Connecting SDI To Data Link Connector Located In Lower Portion Of Instrument Panel (On Driver's Side)
Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
Start up the PC.
Turn the ignition switch to ON (engine OFF), and run the "Application for Subaru Select Monitor".
On the «Main Menu», select {Each System Check}.
On the «System Selection Menu», select {Engine Control System}.
Click the [OK] key after the information regarding engine type has been displayed.
Select {System Operation Check Mode} on the «Engine Diagnosis» display screen.
The following items are displayed on the monitor.