Fuel Pump: Installation
WARNING: This page is about a different car, the 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while being careful of the following.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Align protrusion (A) of the gasket to the position shown in the figure.
- Insert the protrusion (B) of gasket to the fuel pump upper plate. (3 places)
- Align the protrusion (C) of fuel pump assembly with the cutout on the fuel pump upper plate.
- Tighten the nuts to the specified torque in the order as shown in the figure.
- After assembly, install the rubber cap (D) to the position shown in the figure.
NOTE:
- Use a new gasket.
- Do not forget to install the rubber cap (D).
Tightening torque:
4.4 N.m (0.4 kgf-m, 3.2 ft-lb)