Release Bearing and Lever: Installation

• Contact surface of lever and pivot
• Contact surface of lever and bearing
• Transmission main shaft spline

Grease 

NICHIMOLY N-130 (Part No. K0879Y0501) or equivalent 

1. Temporarily assemble the release bearing to the release lever. (turbo model)
2. While pushing the release lever to the pivot and twisting it to both sides, fit the lever spring onto the raised portion of the pivot. (non-turbo model)
   NOTE: Observing from the main case hole, check that the lever spring is installed securely.
3. Install the release bearing by inserting the release lever into the clutch housing release lever hole. Then, fit the lever spring onto the raised portion of the pivot by pushing the release lever to the pivot and twisting it to both sides. (turbo model)
4. Install the release bearing and fasten it with two clips. (non-turbo model)
5. Install the dust cover.
   Fig 1: Identifying Release Lever And Dust Cover

   Courtesy of SUBARU OF AMERICA, INC.
6. Check the bearing for smooth movement by operating the release lever.
7. Apply grease to the contact point of the release lever and operating cylinder.

   Grease 

   NICHIMOLY N-130 (Part No. K0879Y0501) or equivalent 

8. Install the transmission assembly. Refer to MANUAL TRANSMISSION ASSEMBLY .