LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Transmission >> Clutch >> Clutch System >> Clutch Switch >> Inspection >> Clutch Start Switch

Clutch Start Switch

  1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Refer to ADJUSTMENT , Clutch Switch.
    • Make sure that engine does not start with clutch pedal not depressed.
    • Make sure that engine starts with clutch pedal fully depressed.
  2. When the clutch start switch does not operate normally even if it is adjusted, check the clutch start switch for continuity.
  1. Remove the clutch start switch. Refer to REMOVAL , Clutch Switch.
  2. Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not at the standard value, replace the switch.
    Condition Terminal No. Specified resistance
    ON No. 1 - No. 2 Less than 1 Ω
    OFF No. 1 - No. 2 1 MΩ or more
    Fig 1: Measuring Resistance Between Terminal 1 And 2 Of Switch
    G05003714Courtesy of SUBARU OF AMERICA, INC.
  3. Check that the switch is turned on and off in Dimension L.

    Dimension L: 

    4 - 5.5 mm (0.160.22 in) 

    Fig 2: Identifying Switch Length Dimension
    G07913909Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals